![]() ![]() Enter the phone number, or SIP address using your keyboard, or with your mouse using the numeric keypad on X-Lite. Allow it to detect your network environment, and login with ipClouds VoIP.This will take a few seconds – check the Call Status for “Logged in – Enter Phone Number” which indicates that you are ready to make a call.ģ. When you have successfully registered with ipClouds VoIP, you will see “Logged in – Enter Phone Number” as the Call Status Message(see Figure 3) Calling with X-Lite Making a callĢ. Press the Menu button again, to the left of the green Dial button.Īfter you have finished entering all of the necessary settings, close the menu, and X-Lite will register with ipClouds VoIP. Close the settings window by pressing the 'X' in the top right corner.Ĩ. Update settings (if applicable): (not needed)ħ. Provider Website (if applicable): (not needed) Press the Menu button, to the left of the green Dial button.Īuthorization User: your ipClouds VoIP username Setting up X-Lite In order to use the ipClouds VoIP service you have to configure X-Lite manually by following the steps below.Ģ. Getting Acquainted with X-Lite The X-Lite dial pad, along with along with its various controls and indicators is shown below. If you cannot complete the wizard successfully, check to make sure that your devices are plugged in and are working properly for other applications that employ audio. It is strongly advised that you complete the wizard to make sure that your audio devices are working properly and are set at the right level.Ĭlick Next to begin the wizard and follow the steps to complete your audio device calibration. When X-Lite runs for the first time, it will open the Audio Tuning Wizard as shown below in Figure 2.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |